Not spinning, filling wrong, or shaking the floor mid-cycle, most washer problems trace back to one specific worn part. We track it down and get it running again, often the same visit.
Pick what your washer is doing below and we'll tell you what's usually behind it.
Washer Won't Spin
Drum agitates fine but the spin cycle just never kicks in, leaving everything soaked. Nine times out of ten it's a lid or door switch that isn't registering as latched.
Leaking From The Base
A small pool forming underneath partway through the wash. On front-load machines this is almost always the rubber door boot, worn thin or torn at one fold.
Washer Won't Fill
Tub stays bone dry no matter how long you wait after pressing start. Usually the inlet valve has stuck closed, sometimes it's just a kinked hose behind the machine.
Shaking Hard On Spin
Feels like the whole machine is trying to walk across the floor during spin. Suspension springs or shocks wear out over the years and stop absorbing the movement.
Deep Banging Noise
A heavy thud on every rotation that gradually gets worse week to week. This pattern almost always points to a drum bearing wearing down internally.
Stops Mid-Cycle
Cycle halts partway through and throws an error code on the display. Usually a water-level sensor sending the board bad readings, triggering a needless safety stop.
Still Not Sure What's Wrong?
No need to keep guessing, one call gets a real answer and usually a same-day fix.
We've worked on every major name in the business, so nothing surprises us once the panel comes off.
Straight from the people whose machines we've actually worked on.
Send us a few details and we'll follow up shortly to get something booked.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Whether you're near the water or up on the mountain, a technician can usually be at your door the same day you call.
